Dalmatian Light Switch Cover, Black and White Dog Portrait, Single Toggle, Mounting Screws Included

Product details

Bring a little Dalmatian personality to your room with this detailed black-and-white dog portrait light switch cover. The shaped design follows the dog's head and shoulders, with spots and facial detail printed into the face.

WHAT YOU RECEIVE
• One Dalmatian-shaped single-toggle switch cover
• Two mounting screws
The electrical switch is not included. This is a physical printed product, not a digital file.

SIZE AND FIT
Approximately 5.03 inches wide × 5.91 inches high × 0.16 inch thick (127.74 × 150 × 4 mm).
Single-toggle opening: 10.8 × 24.2 mm.
Mounting screw spacing: 2.375 inches (60.325 mm), center to center.
Compare your switch, wall opening and nearby trim with these measurements before ordering. This design is for a single toggle; it is not a rocker/Decora or outlet cover.

MATERIAL AND FINISH
3D printed in black and white PLA. Fine layer lines and small surface variations are normal characteristics of 3D printing. Actual product photographs show the printed cover; additional styled images are AI-assisted marketing composites based on those photographs.

INSTALLATION AND CARE
Turn off power before fitting. Do not overtighten the screws. Keep away from heat and clean gently with a soft cloth. This custom PLA cover is not an electrically certified wallplate and has not been evaluated for flame resistance. Use an approved wallplate where required and have electrical suitability checked before installation.

MADE TO ORDER
Processing time: 5–7 business days.
SKU: SD3-014-001-001-001